CHEAP CONCRETE BLOCKS PLUS

As with our Ready Mix Concrete and Ready Mix Screed we use only the highest quality cement, stone and sand to create our Concrete Interlocking blocks. If you want your wall to have corners, wait to start building the adjoining wall until you’ve built up about 3 to 4 courses of the first one.Concrete Blocksoffer a number of different uses. As you go, check your wall with a level occasionally to make sure the courses are lying flat. Put a thin layer of mortar along the footing and ears of each new block and set them on top of the first row, then tap the layers together with a rubber mallet. To build up your wall, start and end the next layer with a half-block to help stagger the bricks properly. If you’re laying a wall that is 2 courses wide, lay the next course next to the first and fill the space in between with grout or mortar. Keep going until you’ve completed the first course of blocks, and use a trowel to scrape away any excess mortar between the blocks as you work. You’ll want to have about 3/8 of an inch (0.95 cm) of mortar between each block. Use a trowel to add a thin layer of mortar to the “ears” or flanges of the next block where it will meet the edges of the first one, then set it in place. Then, gently push the first block down into the mortar until it’s sitting about 3/8 of an inch (0.95 cm) above the top surface of the footer. Spread a layer of mortar about 1 inch (2.5 cm) thick inside the perimeter you just traced. Use a pencil to trace around the blocks on the concrete footer you poured, then set the blocks aside. When you’re ready to build the base of your wall, lay out the first layer of blocks end to end, and put 3/8-inch (0.95 cm) wooden spacers between each block. Let the concrete harden overnight before moving on to the next step. Next, pour a layer of wet concrete into the trench and smooth it out with a concrete float. Once you start laying the cinderblocks, you’ll also need to put a vertical piece of rebar inside every other hollow space in the blocks and reinforce the bars with coarse core-fill grout. Reinforce each corner of the trench with a piece of steel rebar, each bent at a 90° angle and about half the width of the trench. So, if your blocks are 7 inches (18 cm) long, make the trench 10 inches (25 cm) deep.

CHEAP CONCRETE BLOCKS PLUS

The trench should be about as deep as the cinder blocks are long, plus an additional 3 inches (7.6 cm). Use a shovel to dig a trench inside the area you’ve marked off. Then, run a length of string between each of the stakes to mark off the perimeters of the footing. Once you’ve done this, drive 4 wooden stakes into the ground at each of the corners of the footing area. You’ll also need to decide how long you want the wall to be.

So, if your wall is 16 inches (40 cm) wide, the footing area would be at least 32 inches (81 cm) wide all the way around the base of the wall. Next, calculate the footing area around the wall, which should be at least 2 times as wide as the wall itself. This means that if your blocks are 8 inches (20 cm) wide, the wall will be 16 inches (40 cm) wide. For example, if the wall will be 2 blocks wide, measure the width of a single block and multiply it by 2.

To build a cinderblock wall, start by determining how wide you want the wall to be.

Cheap concrete blocks